Traffic Lights
Episode 6, G1 test prep. 1:15.
Up next: Episode 7, Stop Lines & Road Paint
Play episode 7This episode didn’t load.
Or watch it in the app
Continue in the app
Quiz
Power failure, lights out. Treat it as…
Show the answer
An all-way stop. When a power loss blanks the lights, treat the intersection the same way as one with all-way stop signs.
During an electrical power loss, traffic lights at intersections will not work. … Go cautiously and use the intersection the same way you would use an intersection with all-way stop signs.
Transcript
- 0:01 Sudbury Guru Driving School. Episode six: traffic lights.
- 0:05 Traffic lights tell you when to stop, and when to go.
- 0:08 Green: you may go or turn, after yielding to vehicles and pedestrians in the intersection.
- 0:13 Yellow: the red is about to appear. Stop if you safely can. Otherwise, go with caution.
- 0:18 Red: come to a complete stop, and wait for the green.
- 0:21 Remember: yellow means stop, if you safely can.
- 0:24 Flashing lights, and lights that are out.
- 0:25 Flashing red: a complete stop. Go when it's safe.
- 0:28 Flashing yellow: go through with caution.
- 0:30 Flashing green is an advance green. Oncoming traffic still has a red.
- 0:35 Power out? The lights go blank. Use it like an all-way stop.
- 0:38 Turning on a red.
- 0:39 Unless a sign says no, you may turn right on a red, after a complete stop, once it's clear.
- 0:44 Signal, and yield to pedestrians.
- 0:46 Left on a red? Only one-way onto one-way, after a complete stop.
- 0:52 Quick quiz. The lights are out because of a power failure. You should treat it as...
- 0:60 It's an all-way stop!
- 1:01 Yield to vehicles in the intersection, and to those entering from your right.
- 1:05 Sudbury Guru. Learn it. Drive it. Pass it.